Hewlett Packard 7828A
+
Hewlett Packard 7803B
On the left is a light that says: LOW
On the right is a light that says: HIGH
In the middle it says: HEART RATE/MIN and
there is a gauge that goes from 0 to 250 in increments of 25
with hash marks between increments.
On the bottom left is an OFF ON POWER push button
To the right of that it says: ALARMS OFF
To the right of that is a lever switch with choices: ALARMS OFF ALARMS ON RESET
On the back, on the top left is the power plug port.
To the right of that is a fuse
Below that are 2 areas with ports that have computer board-like end fingers.
It says: ~ LINE
INLET 115/230V ± 10%
50-60 Hz 40 VA MAX
FUSE 115V 300 mAT
230V 150 mAT
Hewlett Packard 7803B
ECG MONITORING SCOPE
On the right you have a knob for CHANNEL 1 POSITION
Below that is a knob for CHANNEL 2 POSITION
On the bottom left is an ON OFF POWER push button
To the right of that is a switch that says: SWEEP MM/SEC and the choices are 25 and 50
On the left side of the front is the scope screen
On the back, on the bottom left are two power plug ports.
To the right of that is a fuse
To the right of that are 4 hole ports that each say: INPUT
Above that area are two male small bolts that says GAIN and the
one on the left says: CHANNEL 1 and the right one says: CHANNEL 2
Above that on the left is an switch with the choices: FREE RUN and SYNC
To the right of that is a hole port that says: SYNC INPUT
To the right of that is a knob that says: INTENSITY
The only cables that came in with this lot are 2 power cables.
One connects both units together.
The other one has a three pronged electrical plug.
We plugged it in and pressed the power button on the 7803B.
The light came on next to the power button.
Two green dots appeared on the screen causing a moving horizontal line graph
that fluctuated as we moved the dials to the right.
We pressed the power button on the 7828A.
The light in the middle came on and the LOW light came on when we moved the
middle alarm switch to ON. The HIGH light additionally lit up as we pressed
the alarm reset switch.
That was the extent of the test.
There are a few dirt smudges and scratches.
There is a mark on the bottom face of the 7803B where a label was removed.
There are some white paint marks on one of the cables.
It will be an AS IS sale.
The law requires that sellers add the following in all medical listings:
"The sale of this item may be subject to regulation by the U.S. Food and Drug Administration
and state and local regulatory agencies. If so, do not purchase the lot unless you are an
authorized purchaser. If the item is subject to FDA regulation, we will verify your status
as an authorized purchaser of this item before shipping of the item."
This item is being offered by Great Lakes Wholesale, Euclid, Ohio 44123.
We are used equipment brokers and surplus dealers.
Logically, ANY medical equipment purchased SHOULD be completely tested by
a qualified medical equipment technician prior to being put into service.
This item is sold used, as is, with no warranty expressed or implied.
The buyer will not hold the seller responsible for the appropriate or inappropriate
use of this device either by the buyer, user or a third party.
It is the sole responsibility of the buyer to assume any and all
liability from the use of this equipment.
plus the shipping cost & handling fee listed below:
to locations in the Contiguous US 48 states
is $ 18.00 to be added to the cost of the lot.
Add any other items or designated lots of capacitors
or electronic components lots from our online store
(when ordered within 24 hours of this lot)
(which do not have a greater shipping and handling cost)
for an additional shipping and handling cost of only $ 3.00 per item
or designated lot plus, obviously, the cost of the items or lots. :-)
> > We accept payment by personal, business and cashiers checks and money orders.
> > Payment must be in US funds and drawn on a US bank.
==> The above quoted shipping & handling cost is to locations in the Contiguous US 48 states ONLY.
other US territories, APOs, or a foreign country:
==> Please E-mail us to obtain the shipping and handling costs for locations in
Alaska, Hawaii, other US territories, APOs, and International locations. <==
==> Shipments to these locations would depend on import/export restrictions placed by the US government and
foreign governments.
==> ANY additional charges to these locations such as taxes, custom & brokerage costs WILL be the responsibility and
liability of the purchaser.
We HIGHLY recommend that IF you are from a destination outside the Contiguous US 48 states and you wish to purchase this item, you have a friend, relative or company in the Contiguous US 48 states PAY for the item and RECEIVE the shipment FOR YOU.
==> We apologize for these restrictions but the increased shipping costs and regulations to those regions makes it quite time consuming and necessary.
